| Quantity: |
|---|
Material: metal + plastic candle, Lantern Size is dia.10 x 22cm height, with 1 x Solar plastic candle, with 1pc flickering Yellow LED, 2V/100MA solar panel, with AAA 300MAH NI-MH battery. w The flickering light is similar like the real candle light effect. Ideal for home decoration even without light; It's also good for decorating your garden / table / house........
During the day, the solar panel converts sunlight into electricity and recharges the battery . At night, the light turns on
automatically using the electricity stored during that day.The number of hours the light stays on depends on your
geographical location,weather conditions and seasonal sunlight availability. Place the solar light fixture in an area where it can receive direct sunlight for at least 8 hours each day.Shadowed locations will not allow the battery to charge fully and will reduce the hours of nighttime lighting. The selected location should not be near nighttime light sources, such as porch lights, street lights or pool lights, as these may cause the solar light to turn off prematurely.
Take out the solar light from package carefully, move the switch on the bottom side of the candle into the position ON.
This solar light is designed for outdoor use. It may for example be placed in garden in a sunny place.
The light must not stand in the water and must not be lighted by means of a lighter or similar device.
Attention: It is absolutely required to make sure that the light has a solid footing due to the metal body,
Please also pay attention to possibly occurring winds.
NOTE : This operation should be done in t he morning on a sunny day. This will allow the light to receive a full 8 hours of sunlight so that the rechargeable battery can reach maximum capacity.
• Move the switch on the bottom side into the position"OFF .
• Unscrew all 6 screws on the battery compart ment of the candle with an adequate screwdriver and remove the cover.
• Take out the plastic seal.
• Remove the battery from the bracket and replace it by a new freshly charged battery of identical size ( Migon, AA )
• Now reinsert the seal into the battery compartment and press the lid back on. Now screw the 6 screws back in again with an adequate screwdriver.
• Move the switch on the bottom side into the position ON.
